Installation Guide

16
OPERATION INSTRUCTIONS
WARRANTY REGISTRATION
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
IMPORTANT: All connections must be wrench tightened
(requires two 10" adjustable wrenches). Do not over-tighten
the connections to the gas pressure regulator. Overtighten-
ing may crack the regulator creating a leak.
NOTE: Do Not rotate the gas pressure regulator.
CONNECT BSPP TO NPT ADAPTER TO GAS REGULATOR:
Apply pipe-joint compound made for use with LP gas to the male
threads of adapter .
Insert adapter into outlet of the gas pressure regulator , and
then tighten using two 10" adjustable wrenches. Be sure flow arrow
on regulator is pointing up toward the range gas inlet pipe.
Install washer in female end of adapter , and then connect
adapter to range gas inlet pipe via compression fitting and
tighten.
1.
CONNECT GAS LINE FROM GAS PRESSURE
REGULATOR TO GAS SUPPLY:
Apply pipe-joint compound made for use with LP gas to
the tapered (NPT) threads of both adapters supplied
with gas line kit.
Attach one adapter to the gas pressure regulator and the
other to the gas shutoff valve and tighten both.
1.
Attach the flexible gas line to adapters , one adapter
at each end.
3.
2.
2.
3.
NOTE: Washer must be used to create a leak proof seal.
INSTALL ANTI-TIP BRACKET
A
A
A
B
B
B
B
C
C
C
CC
C
C
D
A
B
C
D
D
D
D
D
Gas Line from Range Adapter (provided)
Adapter (provided)
Gas Pressure
Regulator
Gas Supply Line
Adapters (From Gas
Supply Line Kit)
Gas Shutoff Valve
Washer (provided) Gas Pressure Regulator
(provided)
D
A
B
C
D
E
E