Installation Guide

INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
17
IMPORTANT: If the range is moved to adjust the leveling legs,
make sure when you move the range back into its final location
that the anti-tip bracket is engaged by repeating steps 1 through
8.
COMPLETE CONNECTION
Open the manual shutoff valve in the gas supply line. The valve is
open when the handle is parallel to the gas pipe.
Test all connections by brushing on an approved noncorrosive
leak-detection solution. If bubbles appear, a leak is indicated.
Correct any leak found.
1.
Slide range into final location, making sure rear leveling leg
slides into anti-tip bracket. Leave a 1" (2.5 cm) gap
between the back of the range and the back wall.
Place the outside of your foot against the bottom front to
keep the range from moving, and then grasp the back of
the range, as shown.
1.
2.
Slide range close to final location.
Plug into a grounded 3 prong outlet.
1.
2.
STEP 5 - MAKE ELECTRICAL CONNECTION
STEP 6 - INSTALL RANGE
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or electrical shock.
Electrical Shock Hazard
WARNING