Use and Care Manual

CLEAN AND CARE

Microwave light (interior)

1 Disconnect power to the microwave at the circuit breaker or by unplugging it.

2 Remove the louver mounting screws from the top center of the louver, then push down on the tabs at each end

of the louver to disengage it.

Louver mounting screws

3 Pull the louver away from the unit.

Louver

4 Open the light cover located behind the lter by removing the light cover screw, then carefully pulling up on the

front edge.

Light cover screw

Light cover

5 Remove the old light bulb, then replace with a new bulb.

CAUTION

Do not use a bulb larger than 30 watts.

6 Replace the microwave light cover by carefully pushing it into place.

7 Push the louver back into place and replace the louver mounting screws.

Louver