ON/OFF Switch. Hold for two seconds to turn ON. Hold to turn OFF. Transmitter Menu Down Button. Please See (System Setup) on page 5. LCD screen. Please See (System Setup) on page 5. Input Level. Controls Level of Rear Panel Inputs. Transmitter Set Button. Please See (System Setup) on page 5. Transmitter Menu Up Button. Please See (System Setup) on page 5. Headphone Jack. Headphone Output Control. Controls Headphone Volume. Turn left to decrease the audio level, turn right to increase.
1 Output Level Control and On/Off switch. 2 Earphone Jack. 3 Antenna. 4 LCD screen. Please See ( S ystem S etup) on page 6. 5 Low Battery Indicator. 6 RF Signal LED. Lights when RF Signal is received. 7 Receiver Menu Up Button. 8 Receiver Menu Down Button. 9 ESC Button. To Exit Menu Setup. 10 SET Button. Use this to select Menu Parameters. Wearing the Bodypack Receiver Belt Clip: For best results, clip the receiver onto a belt by pushing the receiver down onto the belt as far as possible.
Select a Group and Channel: Press “SET” button, “GROUP” will display, press or button to select suitable frequency group number, as shown in Diagram 1 on the left. Then press “ SET” again , “CHANNEL” will display, press or to select suitable channel, as shown in Diagram 2 . on the left. Note: When using multiple systems, for optimum results set all of the systems to the same group number and select a different channel number for each system in that group.
Bodypack Receiver Programming Adjusting Left and Right Balance: Press ▲ or ▼ to adjust left and right earphone balance, as shown in Diagram 1 . “-0-” indicates center balance. Select a Group and Channel: Press “SET” button, “GROUP” will flash, press ▲ or ▼ to select suitable frequency group number, as shown in Diagram 2 on the left. Then press “SET” again, “CHANNEL” flashes, press ▲ or ▼ to select suitable channel, as shown in Diagram 3 on the left.
System Bodypack Receiver Frequency Range and Transmitter Output Level Frequency Range: CODE D 584~607 MHz CODE L 655~679MHz Transmitter Output Level: 10dBm Audio Output Level: 100mW Sensitivity: -94dBm for 30dB Operating Range Under Typical Conditions 300' (92m) Note: actual range depends on RF signal absorption, reflection, and interference Image Rejection: >65dB Audio Frequency Response: +/-3dB 60Hz~16KHz Weight: 3.
A RETURN AUTHORIZATION (RA) NUMBER MUST BE OBTAINED from Galaxy Audio prior to any items being returned to Galaxy Audio for return or repair. Contact customer service @ (800)369-7768. Galaxy Audio warrants the materials and workmanship of its products as follows: A limited THREE YEAR Warranty applies to the following products: 1. HOT SPOTS-including HSRG, HSVC, PA5XD & GALACTIC MONITOR PACKAGE 2. MICRO SPOTS-including MSVC, MSPM, MSPA(DC) 3. CRICKET Polarity Test Set 4.