User Manual

SETTING UP

ANY SPOT

7.3 Inserting batteries into the handheld microphone / bodypack transmitter

Open the battery cover and insert batteries into the battery compartment conforming to the polarity (+)(-)

marks. The transmitter can not work with incorrectly inserted batteries.

AS-MBP5/AS-HH5

Push the ON/OFF switch to “ON” to switch the power on. The LED will flash momentarily. If the batteries have

sufficient power, the LED flashes only once. If the LED stays on, it indicates that the batteries have insufficient

power and should be replaced or charged soon. If the status LED fails to flash, the batteries are either dead or not

positioned correctly, and you should correct the positioning or or charge the batteries

AS-MBP7/AS-HH7

Push the ON/OFF switch to “ON” to switch the power on. A bar graph on the LCD shows the battery power level. Fully

charged batteries will show four bars, while low batteries may show only one bar. If the bar graph displays insufficient

power the batteries should be or charged soon. If the LCD fails to light, the batteries are either dead or not

positioned correctly, and you should correct the positioning or or charge the batteries.

Close the battery cover.

replace

replaced

replace

7.4 Setting up the handheld microphone transmitter

Test the microphone and while watching the RF and AF levels on the receiver, adjust the levels on your audio mixer

or amplifier.

7.5 Setting up the bodypack transmitter

A. Connecting a microphone

Test the microphone and while watching the RF and AF levels on the receiver, adjust the levels on your audio mixer

or amplifier.

B. Connecting an instrument

Play the instrument and adjust the levels on your audio mixer

or amplifier.

Switch ”ON” the transmitter.

Switch the receiver power on and make sure the frequency selected on the receiver matches the one selected

on the transmitter.

Plug the mini XLR connector of the microphone cable into the audio input connector on the bodypack

transmitter.

Switch “ON” the transmitter and receiver. Make sure the frequency selected on the receiver matches the one

selected on the transmitter.

Open the battery cover. Push the MIC/LINE switch to “MIC” and use the supplied screwdriver to adjust the

GAIN to an appropriate position. The receiver’s AF level should peak into the red only on the loudest signals.

Plug the ¼” (6.3mm) phone plug of the optional line cable into the output jack on the instrument and the

mini XLR into the audio input connector on the bodypack transmitter.

Switch “ON” the transmitter and receiver. Make sure the frequency selected on the receiver matches the one

selected on the transmitter.

Open the battery cover. Push the MIC/LINE switch to “LINE” and use the supplied screwdriver to adjust the

GAIN to an appropriate position. The receiver’s AF level should peak into the red only on the loudest signals.

while watching the RF and AF levels on the receiver,

WIRELESS MICROPHONE

UHF