CK USER'S MANUAL ® CK-HH, CK-H2, CK-PEN, CK-SBPR, & CK-VBPR UP SET DOWN ® MAKERS OF THE ORIGINAL HOT SPOT PERSONAL MONITOR
This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit. WARNING! USING THIS SYSTEM AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE. In order to use this system safely, avoid prolonged listening at excessive sound pressure levels.
Table of Contents Page 1. Safety ..................................................................................... Inside front cover 2. Contents .......................................................................................................... 1 3. Introductions .................................................................................................... 2 4. AS-TVHH Handheld ......................................................................................... 3 5.
GALAXY AUDIO ANY SPOT WIRELESS CAMERA SYSTEMS Introduction Thank you for purchasing the Galaxy Audio Any Spot Camera System! This system operates in the UHF Frequency band and utilizes a Phase Locked Loop (PLL) synthesizer control for improved reception and channel selection. The system provides 96 selectable frequencies making it easy to avoid frequency interference. Camera Kits are great for field reporting or anytime live audio/video is recorded or transmitted.
Description of Functions for Handheld Microphone AS-TVHH Front Panel Wind Screen: Protects cartridge with Pop Filter. Main Body: Contains Wireless Transmitter PCB. SET button for channel settings Rear Panel Volume Control: Three level settings, including mute, LOW and HI. LCD panel: Channel and frequency display. UP and DOWN buttons: For Channel select and Frequency display. LED: Power status MUTE LOW HI Pushing point: Slide the battery cover down by pressing here.
Operation of Hand Held Microphone AS-TVHH A. Battery Installation Steps: 1. Turn off the microphone before inserting batteries. 2. Press in the latch to release the lower housing and slide it off. 3. Press in the latch to release the battery cover and slide it down. 4. Insert 2 disposable batteries of 1.5V type or 2 rechargeable batteries of 1.2V type. 5. Observe proper polarity while inserting batteries. 6. Slide the battery cover back to its original position. 7.
E. LCD Indications: 1. :Three bars means batteries are fully charged. 2. :One bar indicates low batteries. Replace or recharge the batteries. 3. :No bars showing indicates batteries are exhausted and after flashing three times the power will automatically shut off. F. Battery Charging Steps: 1. Rechargeable batteries need to be NiMH AA 1.2V with an amperage of 2100mAH or less as the charging function is limited to batteries of that rating. 2.
c. Check if the distance between the transmitter and the receiver is too great. d. Check if the transmitter or the receiver is too close to any large metal objects. 5. Interference and signal Disturbance. a. Make sure there are no other wireless systems operating on the same frequency in the same area. This includes Microphones, televisions, radio stations, etc. Try setting the transmitter and receiver to a new channel. H. Q&A 1.
Operation of Handheld Microphone AS-TVH2 A. Battery Installation Steps: 1. Turn off the microphone before inserting batteries. 2. Press in the latch to release the battery cover and slide it down. 3. Insert 2 disposable batteries of 1.5V type or 2 rechargeable batteries of 1.2V type. 4. Observe proper polarity while inserting batteries. 5. Slide the battery cover back to its original position. B. Switch-On Steps: 1.
3. With the switch in the Push position the microphone is muted until you press and hold the mute button. 4. In either position, when the mute switch is green the microphones is on, when the mute button is red the microphone is muted. F. LCD Indications: 1. :Three bars means batteries are fully charged. 2. :One bar indicates low batteries. Replace or recharge the batteries. 3. :No bars showing indicates batteries are exhausted and after flashing three times the power will automatically shut off.
Operation of AS-TVBPT Transmitter A. Switch-On Steps: 1. Press the power switch and hold for about two seconds until the LED turns to Blue and is displayed in the LCD. 2. The LCD will then automatically display the selected channel. B: Volume adjust 1. Press the + button to increase press the – button to decrease. The range is 3 steps D. Channel/Frequency Settings (with power on): 1. Press the Set button in and hold for about 3 seconds. 2. The Channel number display will start flashing. 3.
Operation of AS-TVMBP Body Pack Transmitter A. Battery Installation: 1. Switch the transmitter off before inserting batteries. 2. Slide the battery cover off. 3. Insert 2 disposable batteries (1.5V AA) or 2 rechargeable batteries (1.2V AA). 4. Observe correct polarity when inserting batteries. 5. Slide the battery cover back to its original position. B. Turning unit on: 1. Switch the power to ON position 2. The RED LED will light and the LCD will display "On". Battery status and channel will then appear.
E. Battery Charging Steps: 1. Insure that the batteries are the rechargeable type. 2. Switch Power to OFF position. 3. Insert AS-TVMBP into its own intelligent charger stand (AS-DCTVMBP). 4. Batteries will recharge automatically. 5. For more details of charger stand please refer to AS-DCTVMBP user guide. F. Turning the unit OFF: 1. Slide the power switch to the OFF position. 2. LCD display will show “OFF” If there is no further operation, the Power LED and LCD will switch off automatically. G.
Description of Functions for Body Pack Receiver AS-TVBPR 10 8 5 6 7 4 11 9 1 2 12 3 1. MUTE button 2. Channel 3. LCD 4. Power / Volume button 5. Audio out / Headphone jack 6. Charging indicator (built-in) 7. Line out 8. Strap attachment point 9. DC charging input 10. Strap attachment point 11. Belt clip 12. Charging terminal Operation of AS-TVBPR Body pack Receiver A. Switch-On Steps: 1. Turn the power/volume switch clockwise is displayed in the LCD. 2.
D. Channel/Frequency Settings (with power on): 1. Press the + button to display a higher numbered channel. 2. Press the - button to display a lower numbered channel. 3. Press the set button to display the frequency. E. Switch Off steps: 1. Turn the power/volume control completely counter clockwise until it clicks off. F. Charging the AS-TVBPT and AS-TVBPR 1. These units have permanent rechargeable lithium batteries. 2.
distorted, try decreasing the Gain control (turn counter-clockwise) on the AS-TVMBP. 5. Once a frequency has been selected, additional Receivers may be set to the same frequency and audio quality verified. 6. A general rule for any wireless system: Any number of Receivers may be set to the same frequency and used in the same area. However, only one transmitter may be used on a selected frequency in any given area.
Bodypack Transmitter (AS-TVMBP) (continued) Channel select SET, UP, DOWN keys AF controls Mute switch, Hi/Mid/Low switch Audio input Mic in, Aux in Batter y 1.2 V (Ni-MH 1300 mAh) * 2 AA type rechargeable battery 1.5V * 2 AA Alkaline disposable Batter y life Ni-MH rechargeable 11 hours typical Batter y life Alkaline disposable 14 hours typical Housing Aluminium Dimensions ( D x W x H ) 1.04" x 2.52" x 3.48" (27 x 64 x 88 mm) Weight with batter y 4.48 oz.
Pendant Transmitter (AS-TVBPT) 16 Oscillation type PLL Synthesized control OSC Frequency Range 640~664 MHz Selectable Frequencies Pre-programmed 96 switchable frequencies Microphone Electrical Condenser RF Power Hi: below 10 dBm and Low: 4± 2 dBm Max. Modulation ±80 kHz, with level limiting T.H.D < 1% @ f = 1 kHz, MIC IN = -30 dBv AUX Modulation level 7 ± 0.5 kHz @level=-20 dBv, f=1 kHz. MID Tone Frequency / Modulation 38 kHz / 2.5 ± 0.5 kHz.
Bodypack Receiver (AS-TVBPR) Model no. AS-TVBPR Frequency Range UHF 640~664 MHZ Adjustable Frequencies Pre-programmed 96 switchable frequencies Case Plastic Oscillator PLL synthesized Receiving Mode PLL Single channel Sensitivity Sinad > 20 dB @ Ear.out:500 mV, RF=-105 dBm, f=1 kHz, Mod=14 kHz. AUX output level @ 1kΩ 300 mV 2RF=-60 dBm, f=1 kHz, Mod=14 kHz Ear. output level 1.4V @ VR max., RF=-60 dBm, f=1 kHz, Mod=14 kHz. <1% @ Ear.out:500mV, RF=-60 dBm, f=1 kHz, Mod=14 kHz. Ear. output T.
OPTIONAL ACCESSORIES omni directional heaset (dual ear) can also be used as a lapel microphone, mini XLR plug, works with the AS-TVMBP uni directional lav/lapel microphone, mini XLR plug, works with the AS-TVMBP Holds body pack receivers, body pack transmitters or handheld microphone, and accessories.
TROUBLESHOOTING Problem No Sound Sound interference Distortion Solution Meoi ™©¶i f §´l ´l i ´¶e¢™ü ḿ´i ¶ e¢h ¶i gi m ∑i ¶ e¶i ™®ḿgl i h on and receiving power. Meoi ™©¶i ´l i ´¶e¢™ü ḿ´i ¶ e¢h ¶i gi m ∑i ¶ e¶i ´©¢i h ´§ ´l i same frequency program number. Meoi ™©¶i e¢ e©hm § ™m k¢eòm ™f i m ¢k ™©• • òm i h ´§ ´l i transmitter. Meoi ™©¶i ´l i ¶i gi m ∑i ¶ m ™®ḿl m ¢ ¶e¢ki §j ´l i ´¶e¢™ü ḿ´i ¶.
20
Certification AS-TVBPR: Approved under the Declaration of Conformity (DoC) provision of FCC Part 15. Meets essential requirements of European Union R&TTE Directive 1999/5/EC, eligible to bear CE marking. Type approved to EN 300 422 -2. Meets requirements of EMC Standard EN 301 489 Parts 1 and 9. This Radio Equipment is intended for use IN MUSICAL PROFESSIONAL ENTERTAINMENT AND SIMILAR APPLICATIONS. NOTE: This Radio apparatus may be capable of operating on some frequencies not authorized in your region.
THREE YEAR LIMITED WARRANTY WARRANTY Information can be viewed online at http://www.galaxyaudio.com/warranty.php ANY SPOT CAMERA KIT USER'S MANUAL Specifications in this manual are subject to change without notice. For the most up to date manual and information visit www.galaxyaudio.com. 1-800-369-7768 www.galaxyaudio.com © Copyright Galaxy Audio 2013 Printed in the U.S.A.