Owner's manual

• Menu “LIN/RIN” Equalizer’s Channels Editing [access by pushing the “LIN/RIN”

buttons]

From the “Default Screen”, it is possible to access the “LIN/RIN” editing menu by pushing the “LIN”

or “RIN” button. Once the button is pressed, the related blue “EDIT” LED will turn ON. The

Sub-Menu pages can now be scrolled through by rotating clockwise and counter-clockwise the

“NAV/PM1” encoder.

For parameter editing, it is necessary to press ENTER and an arrow will appear on the left of the

screen “->”. Then use the “PM2” and “PM3” encoders for selecting and setting the parameter

values. On some parameters that have three independent values, you will also need to use the

PM1 encoder, eg filter parameter settings.

Note: All parameter editing can be done using the “NAV/PM1”, “PM2”, and “PM3” encoders and the

current shown value of the selected option is AUTOMATICALLY loaded during the encoders’ use

and stored as the current value once leaving the page.

Name page - from this screen it is possible to assign a 6 character name to the Equalizer’s

Channel.

The following is an example screen for a “Name” page labeled “Left” for the Equalizer’s Channel

LIN [A]:

To Edit press ENTER on the Name Page and the entering arrow will appear as in the example

below:

The first letter position will be blinking.

Select the Character position from the 6 available by rotating the “NAV/PM1” encoder, then by

using the “PM2” or “PM3” encoder it is possible to select the desired character.

OutputA Left Name

Name = Left

DPA-240A

1x2 WAY X-OVER

OutputA Left Name

->Name = Left

Once you are happy with your name selection, press “ENTER” to confirm the edited Name. The

New name will be stored. The following example shows “Ch[A]” replacing our previous name of

“Left”:

DPA-240A

1x2 WAY X-OVER

OutputA Ch[A] Name

Name = Ch[A]