User Manual

Transmitter
Receiver
Galaxy Trek Disc Transducer System GT-INST-1
GT-INST-1
Galaxy Trek Disc Transducer System GT-INST-1
1. Put the receiver into the 1/8" (3.5 mm) Mic input of an amplifier, powered speaker, or other
audio device or use the included 1/4" (6.5 mm) adapter for 1/4" inputs. For Apple or Android
phones, use the included phone adapter cables.
2. Attach the adhesive pad to the Disc Transducer, then the included Belt Clip to the Transmitter.
3. On the Receiver, move the Power switch to On. The LED will begin flashing.
4. On the Transmitter, move the Power switch to On. The LED will briefly flash until the
Transmitter and Receiver automatically pair. The LED will then remain on.
5. Adjust the volume to a suitable level. It is ready for use.
Caution
The LED will turn red when power is low, and will turn off when
less than 10%. The LED will also turn red when charging.
Store in a dry location away from moisture. Avoid excessive heat.
For repair services, please contact Galaxy Audio. Do not attempt
open or repair it. Doing so will void warranty.
System Specifications:
Frequency Range: 2.4GHz Frequency Hopping
Frequency Response: 10Hz-10KHz
Pairing: Auto-Match
Disc Transducer:
Diameter: 0.94" x 0.94" x 0.25" (24 x 24 x 6.5 mm) (LxWxD)
Transmitter:
Controls: On-Off Power Switch, Volume Control
Battery: Lithium-Ion Rechargeable
Input: Mini USB Charging
Indicators: Power and Pairing LED
Receiver:
Controls: On-Off Power switch
Battery: Lithium Ion
Input: Mini USB charging
Output: 3.5mm stereo output plug
Indicators: Power and Pairing LED
Included Accessories:
Detachable Belt Clip
Cell Phone Adapter Cables (Red for most Android, Black for most Apple)
1/8 inch to 1/4 inch Adapter
USB Charging Cable
19.7 inch Female to Male Extension Cable
(6) Adhesive Pads
*Try placing in different locations to find
the best sound suited for your needs.