User Manual

are smaller than the core diameter of the screw. Always use

fasteners in all mounting holes and avoid over tightening, as this

can weaken the mounting surface, damage the fasteners, and

make the installation much less secure.

SECONDARY SUPPORT: As we recommend the use of a

secondary support for added safety, each yoke bracket is

equipped with a safety cable. When properly installed it provides

secondary support without inhibiting the adjustment of the

bracket, and can be easily hidden out of sight.

MOUNTING PROCEDURE:

PREVIEW: After evaluating the mounting surfaces and obtaining

the appropriate fasteners, the installation will consist of the

following steps, in order:

1. Mounting the bracket plate to the wall or ceiling.

2. Bolting the yoke to the plate.

3. Joining the cabinet with the bracket assembly.

4. Installing the safety cable.

5. Adjusting the speaker position and tightening the yoke

bolt and wing screws.

TOOLS REQUIRED: You will need at least these tools for installation:

7/16" box end wrench

Large crimping pliers

Tools to secure the fasteners selected for the bracket

assembly (drill, screwdrivers, etc.)

Carpenter's level for precise positioning of the speaker.

Note: It is often helpful to have another person available to hold the

speaker in place during the tightening procedure.

INSTALLATION:

ATTACHING THE BRACKET ASSEMBLY TO THE MOUNTING

SURFACE:

Position the bracket assembly onto the wall or ceiling at the location

you have selected, preferably to a stud, joist or other structural

member rather than only to drywall or other non-structural material.

Make sure there will be enough clearance to rotate and tilt the

speaker to the desired angle. Using the base plate of the bracket

assembly as a template, mark the four hole locations.