Installation Guide

Programming example:
• Set the irrigation duration to “Min 15” and the
irrigation cycle time to “1 Day”.
• When you press
the faucet/tap opens
immediately, and remains open for 15 minutes.
The valve will open at the same time every day for
a duration of 15 minutes.
• Irrigation will start every day at the time you pressed
the button on the first day.
1. Make sure the filter is in place.
2. Screw the female swivel connector to the faucet/
tap (hand tighten only).
3. Connect the controller male hose thread connection
to your system.
4. Press in the middle of the keypad to start
irrigation. The faucet/tap opens and irrigation will
commence for the configured duration and cycle
times. When the faucet/tap opens you will hear a
click and will appear on the screen.
Computerized Control Systems
Kfar-Blum 12150, Tel. [phone], Fax. [phone]
E-Mail: [e-mail], www.galconc.com
GALCON 11000EZ
Computerized
Irrigation Controller
Instructions
1. Female swivel connector.
2. Interior filter.
3. Controller cover.
4. LCD screen.
5. Controller body.
6. Programming and operation buttons.
7. Male hose thread connection.
8. Battery compartment.
1. Open the controller cover by rotating the controller
body.
2. Hold the controller with the battery compartment
facing you.
3. Pull the battery compartment cover to open the
compartment.
4. Connect an alkaline 9V battery to the battery
connector.
5. Insert the battery into the battery compartment
and close the compartment by pressing its cover.
Before changing a battery, make sure the battery
compartment is dry.
After the battery compartment is closed and you
finish programming the controller, rotate the controller
back to its original position, so that the LCD screen is
covered by the controller’s cover.
Regular irrigation program
1. Open the controller by rotating the controller body.
2. Select the irrigation duration using the arrow
buttons
on the left side of the keypad to
increase or decrease irrigation time. An arrow
will appear on the screen next to the selected
duration.
3. Select the irrigation cycle time (time between
irrigation starts) using the arrow buttons
on
the right side of the keypad. An arrow will
appear on the screen next to the selected cycle
time.
Energy saving feature
This controller has an energy saving feature which
enables the battery to last for at least two years.
To save energy, the display on the LCD screen
disappears after a few minutes if no buttons are
pressed. Pressing any button causes the display to re-
appear, without changing the configured program.
1. COMPONENTS IDENTIFICATION 2. BATTERY INSTALLATION 3. CONTROLLER INSTALLATION 4. IRRIGATION PROGRAMMING