User Manual

Part number 3E0000 R3

April 2002

Mounting

Note: The Prox 125 reader has been designed to metric specifications therefore any

imperial measurements provided are approximate only.

The Prox 125 reader is designed to be mounted on any solid flat surface including metal

surfaces. In addition the optional cradle base allows you to mount the reader over most

standard international flush boxes.

Optional Cradle Base

Cabling Hole

Mounting Holes

Mounting Hole

Facia Screw Hole

Drill the holes for the mounting screws.

Note: The recommended mounting height for the Prox 125 reader is 1100 mm from

floor level to the centre of the reader unit. However this may vary in some

countries and you should check local regulations for variations to this height.

The type of flush box you are using, if any, will determine which mounting holes you use.

Run the building cabling through the cabling hole.

Fit the base to the mounting holes and secure it to the mounting surface using two fixing

screws.

Note: It is very important that the base of the reader is flush with and tight against

the mounting surface. If you are mounting the Prox 125 reader on a rough

surface you should make the surface as smooth as possible under the reader

and up to 25 mm (1 in) around the reader.