User Manual

9
Part number 3E0000 R3
April 2002
Set DIPSW2 as follows, where 0 = OFF and 1 = ON:
Reader
DIPSW2
12345678
Prox 125 only, no authorised exit 00000000
Prox 125 only, with authorised exit 00000100
Prox 125 with external keypad, no authorised exit 00000011
Prox 125 with external keypad, with authorised exit 00000111
CAUTION
Do not fit the lithium battery jumper (J1) before powering up
the URI. If the jumper is fitted you must remove it and wait 10
seconds.
Power up the URI.
The yellow LED (D45) should be permanently ON. This indicates that 5 V is present on
the board.
The green LED (D44) should flash twice, pause, then flash twice again. This is a
continuous sequence while the URI is unitialised and indicates it is processing.
The red LED (D8) should flash if polls are received from the Commander.
Note: A URI can be initialised without being connected to a Commander
Set DIPSW1:7 to ON.
Present a Prox 125 card to the Prox 125 reader.
Note:You must present the card within 30 seconds of setting DIPSW1:7 to ON. If
you are initialising with two readers connected to the URI, you should present
the card to the reader on URI plug P5.
Set DIPSW1:7 to OFF
The green LED (D44) will begin flashing continuously.
The other red LED (D10) will flash each time the URI replies to a poll from the
Commander.
Fit one of the berg mini jumpers supplied in the URI dispatch kit across both pins of the
lithium battery connector J1.
Restore the tamper by closing the door of the URI cabinet.
!