User's Manual

User Manual Gallagher SmartReader BR Series
28
Dual-Reader Mode
This option enables increased Electronic ID reading performance, using two
panel readers, which can be connected to operate in tandem as a Dual-Reader.
If you are unable to get a consistent 100% read of animals in a race, then the
Dual-Reader option may deliver the required performance.
Positioning two panel readers opposite each other on either side of a race,
enables them to be operated as if they were a single reader with a larger read
range. This provides a solution that works across races up to 1.2 metres wide.
However, it is important the animals move through the race in single file to
avoid a missed read.
The readers are installed as a master (primary reader) and slave (secondary
reader). Once you have installed both SmartReaders you will need to change the
settings in each SmartReader via the Configurator program on your computer.
Note: To use the Dual-Reader mode, you will need vSR1.09//b03 of reader
software and v2.12.0.15 of SmartReader Configurator software, or higher
versions.
Procedure
1. Connect the SmartReaders to a data collection device. (PC, TSi, SmartScale)
- For a wired connection between the readers, refer to Dual-Reader Wired
Installation (p 29).
- For a Bluetooth connection between the readers, refer to Dual-Reader
Wireless Installation (p 31).
2. Turn the Primary SmartReader to ON or Memory.
3. If the Dual-Readers are connected to a PC/laptop, open the Configurator
software.
Double-click on the Configurator icon on the desktop.
OR
a) Click on the Windows Start button.
b) Select All Programs (Windows XP) or Programs (Windows 2000).
c) Select MyScale.
d) Click on SmartReader Configurator.
4. Click
.