User's Manual

User Manual Gallagher SmartReader BR Series
4
Buttons
The following table describes the function of each button.
Button Function
Reset Counter
Only operational when the SmartReader is in ON mode.
Press the Reset Counter button to reset the counter
on the SmartReader.
New Session
Only operational when the SmartReader is in MEMORY
mode.
Press the New Session button to create a new session
on theSmartReader and add all new Electronic ID tag
reads to this session.
All previous sessions are maintained until they are
downloaded to the computer via MyScale Pro.
A new session is created each time the SmartReader is
turned on.
Volume
There are two volume levels on the SmartReader ON
and OFF.
To change the volume on the SmartReader while it is
operating, press the Volume button.
Note: Warning beeps (low battery warning etc) ignore
the Volume setting and beep as required.
Audible beep
The SmartReader beeps whenever one of the following situations occurs:
• An Electronic ID tag has been read, except if the volume is set to OFF.
• The volume level is set.
• The battery charge level is low. This warning sounds regardless of the
volume set.