Instruction manual

IV. USE OF VACUUM CLEANER

According to the selected cleaning activity, use either the vacuum cleaner alone and

select accessory E or assemble the vacuum cleaner with an extension adapter and select

accessory D. The floor nozzle with a rotation brush D is intended for vacuuming carpets

with low pile or smooth flooring. You can use crevice nozzle E1, for vacuuming places that

are hard to access. In case of using the cleaner A without the body of the rod cleaner B,

turn it on/off by switching the switch A1.

If you will be using the cleaner assembled, you can turn it on/off with the switch B1. When

control light D1 is on, it signals operation of the rotation brush. Let the vacuum cleaner

recharge as soon as its suction performance gets weaker. In the case of everyday use,

do not disconnect the battery charger from the electric socket. In this way the appliance

will always be fully loaded. Battery overcharging is not possible. If you are not present

for longer time (more than one day), remove the charger from the electric socket to save

energy.

CAUTION

– The floor nozzle with the rotation brush is not intended for vacuuming impurities from

carpets with high pile.

– If the rotation brush is blocked during operation (e.g. due to sucking in large foreign

objects, due to winding carpet piles, threads or hair on them etc.) turn off the vacuum

cleaner by switch A1 or B1. Then remove the cause of blocking or clean the rotation

brush if necessary (see par. V. MAINTENANCE).

Emptying dust container

If you find out that the suction performance of the vacuum cleaner is reduced, make sure

that the dust container is not full and if necessary, empty it. After pressing the dust bin

arrest button A2, remove the container from the cleaner by pulling slightly (pic. 4). Pull

out micro-filter E4 and filter protector E5 from the container, then place the container over

a dustbin and empty it into common municipal waste (Fig. 5). For sanitary reasons we

recommend emptying the container outside residential premises.

Cleaning dust container and cleaning filter

After the container has been emptied about 5 times, we recommend complete cleaning

of the suction system from the settled dust. All parts (e.g. container, micro-filter, filter

protector) can be cleaned in running lukewarm water (e.g. using a cloth or a soft brush)

and let to dry thoroughly. Re-assemble individual parts in the opposite direction after it is

completely dry.

CAUTION

– Never vacuum impurities without protective filters on.

– The maximum suction effect will be reached with a clean micro-filter and an empty

container.

– Do not use any aggressive washing or cleaning agents or hot water to clean the

micro-filter.

– The micro-filter is not intended for washing in a dishwasher!

– The dust container is not resistant to cleaning in a dishwasher!

/ 43