Artist Ser ies 1001RB-II/700RB-II Owner’s Manual 1001RB-II/700RB-II 1001RB/115 700RB/115 1001RB/210 700RB/210
Table of Contents 700RB-II/1001RB-II Series Table Of Contents Introduction..................................................................... 3 Safety Information........................................................... 5 Quick Start....................................................................... 6 Bi-Amp and Normal Operation....................................... 7 Sound Tips....................................................................... 8 Settings and Sounds...........................
700RB-II/1001RB-II Series Congratulations Gallien-Krueger, Inc. 2234 Industrial Drive Stockton, CA 95206 phone: (209) 234-7300 fax: (209) 234-8420 Internet: www.gallien-krueger.com Email: sales@gallien.com To get the most out of your new purchase please take a few minutes to read through this manual. If you are in a hurry, we suggest you at least read through the Quick Start and Safety Information sections before setting up your new rig.
700RB-II/1001RB-II Series Introduction GK Philosophy I have never seen the point in doing things the way others have done them. I also have not been very interested in following the latest fad. I am a Stanford educated engineer who worked his way through school as a musician. Like all musicians, I have lugged amplifiers up stairways and into car trunks, always wondering why these things had to be so heavy, bulky, and hard to handle.
700RB-II/1001RB-II Series Safety Information To avoid safety hazards, use only the power cord supplied with your unit. If a replacement cord is used, make certain that it is of consistent quality and gauge as the original. We do not recommend using extension cords with this product. As with all electrical devices, do not run power cords under rugs or carpets or place heavy objects on them. Damaged power cords should be replaced immediately with cords meeting factory specifications.
700RB-II/1001RB-II Series Quick Start Quick Start The 1001RB-II/700RB-II is designed to be simple to operate. All controls have a well defined purpose and are well behaved. These directions will take you through the basics and give you a good start for setting up your sound. 1. Plug it in: 3.
00RB-II/1001RB-II Series Bi-Amp & Normal Operation Bi-Amp and Normal Operation The 1001RB-II/700RB-II’s unique design allows for easy setup into Bi-Amp or Normal configurations. The operational mode is configured by how you connect your speaker cabinets. In addition, you have the option of driving one cabinet in Bi-Amp and one with Normal operation.
700RB-II/1001RB-II Series Sound Tips Sound Tips The 1001RB-II/700RB-II Series has several unique features which, if used properly, will obtain that sound you have been searching for. The Equalizer: Boost/Master: The Equalizer is used to fine tune your sound. When adjusting it, do it just a little at a time. These are active circuits, and small changes can make a big difference in your sound.
700RB-II/1001RB-II Series Settings and Sounds: 1001RB-II & 700RB-II * Contour note: At higher playing levels the contour should be set lower for mid-range clarity. To get 800RB voicing, the contour should be set to 0 or 10 only. * VVoo l u m e n o t e : Adjust volume before playing these recommended settings. Slap: Both pickups recommended. Rock: Both pickups recommended. Reggae: Front pickup recommended. Jazz/Fusion: Both pickups recommended.
Installation & Maintenance 700RB-II/1001RB-II Series Installation and Maintenance . Installation: Cleaning: · When the unit gets dirty, clean only with a dry cloth. Never use benzene, thinner, alcohol, or other volatile cleaning agents. Do not use abrasive cleaners, as they may damage the finish of metal parts. Avoid spraying insecticides near the unit. . . .. · · To insure proper operation and to avoid potential safety hazards, place the unit on a firm, level surface.
700RB-II/1001RB-II Series 1-Balanced Direct Out: An electronically balanced output, that you can run to your P.A. system. 2-Ground/Lift: This switch disconnects the ground on the balanced, XLR output to eliminate hum and buzz when connnecting to equipment that is running on a different groundsystem. Pre/Post EQ Button: Selects the direct out signal before or after the EQ. 3-Direct Level Out Controls the level at the direct out jack.
Rear Panel Controls 700RB-II/1001RB-II Series 2 1 3 Rear Panel Controls 1- AC Receptacle: The power cord is detachable and plugs in here. CAUTION: 2- 700W/480W Amp Only: 700W/480W power amp output for Full-Range operation only. They deliver 700W/480W into 4 Ohms. Lower impedances should not be used. Higher impedances such as 8 Ohms, 16 Ohms, or No Load are acceptable. One 8 Ohm cabinet is okay. One 4 Ohm and one 8 Ohm is not recommended.
700RB-II/1001RB-II Series 1001RB-II/700RB-II Series Combos Lock N’ Roll Transport System: The Lock N’ Roll transport system is designed for quick and easy rolling of the combo on flat surfaces such as carpet, flooring, pavement, etc. To engage the lock and roll handle, first move the combo into the upright position (front perpendicular to the ground).
700RB-II/1001RB-II Series Tech Talk Tech Talk growl and keep the definition that the horn provides. The horn always has to be turned down. In a Bi-Amp system like the 1001RB-II/700RB-II Series, the woofer and the horn, each have their own power amp, allowing us to get growl in the woofer only, while keeping the horn sound crystal clear. Now you can over-drive the woofer as much as you want, and leave the horn all the way up, keeping the definition it brings to your sound.
700RB-II/1001RB-II Series Voicing Filters: Voicing filters are used to completely re-voice the amplifier. In the case of the Contour and String Bass controls, the effect is dramatic. a low speed, reducing fan noise. As the amp works harder, the fan speed increases to keep everything cool. The way a Bass amp deals with the instrument low string is a critical part of it’s sound. In fact, a five string instrument requires an entirely different low end response than a four string instrument.
700RB-II/1001RB-II Series Specifications Block Diagram 1001RB-II/700RB-II Series Specifications: Output Power: 1001RB-II: 700W Amplifier 700RB-II: 480W Amplifier 50W Amplifier Cooling: 460W @ 8 Ohms 700W @ 4 Ohms 320W @ 8 Ohms 480W @ 4 Ohms 50W @ 8 Ohms 75W @ 4 Ohms Input Section: Maximum Input Level 0.6V Rms With -10dB pad 1.