SDS

MATERIAL SAFETY DATA SHEET
Manufacturer：BST POWER(SHENZHEN) LIMITED Date: Dec,2013 VER：3.0
Page 4 of 10
or earth). Scoop contaminated absorbent into an acceptable
waste container. Collect all contaminated absorbent and
dispose of according to directions in Section 13. Scrub the
area with detergent and water; collect all contaminated
wash water for proper disposal.
Section 7. Handling and Storage:
Handling/Transportation
Do not open or disassemble the batteries. Do not expose the batteries to
fire or store near open flame. Do not mix batteries of varying sizes or
chemistries. Do not connect the positive and negative battery terminals with
conductive material or throw into fire. Do not heat or solder the batteries.
Keep the batteries in plastic or non-conductive trays. Do not expose
batteries to direct sun light for a prolonged time. Do not expose cell to
temperatures outside the range of -40°C to 80°C.
Storage
Batteries should be stored in a well ventilated, cool area with sufficient
clearance
between batteries and walls. Store the batteries in a cool (below 30 ℃)
area and away from
moisture. Keep the batteries away from sources of heat, open flames, food
and drink. Do not store the batteries above 55 ℃ or below -30 ℃ .
Storing at elevated temperatures may reduce the life of batteries. Keep
batteries away from strong oxidizers and acids. Elevated temperature
storage such as 100 ℃ may result in battery venting flammable liquid and
gases.
Section 8. Exposure Controls/Personal Protection:
No engineering controls are required for normal operation. In case of cell leakage, increase the
ventilation and use self contained full-face respiratory equipment.
Common Chemical
Name/General Name
OSHA PEL-TWA ACGIH (2010) and TLV-TWA