Manual

CF-19 WEDGE
INSTALLATION INSTRUCTIONS
Product Revision Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
7160-0073
Rev C
INST-353
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
Tools Required
7/16 wrench or socket
The purpose of this installation instruction is to illustrate the manufacturer's recommended
method of installation of the CF-19 Wedge to the CF-19 Docking Station.
Assembly
1. Begin by aligning the CF-19 Docking Station in the desired position over the
Wedge.
2. Fasten the docking station to the Wedge using the (4) .25-20 x .75 hex head cap
screws provided.
CF-19 WEDGE
CF-19 DOCKING STATION
4 X .25-20 x .75 HHCS
(Mounting Hole Locations)
7.19
.31
9.41 .51
4X .28 q HOLES