User Manual

2 of 4
There are three ways to install and attach the Workstation to the vehicle floor.
Two require drilling holes into the vehicle floor, the third uses the existing seat bolts:
#1 - The box alone, without Adjustable Legs, can be attached to the vehicle floor.
Mounting holes are provided in the bottom of the Workstation (see Fig. 1).
#2 - The Workstation can also be attached to the vehicle floor using the Adjustable Legs
(see Fig 2).
Using the Adjustable Legs allows setting the Workstation at a convinent height or to
compensate for an uneven vehicle floor.
The Adjustable Legs allow 2.5" of vertical adjustment.
For shipping, the Adjustable Legs are wrapped and stored inside the box.
Attach the Legs to the Workstation with (4) .38-16 x .75 Hex Head Screws and (4) .38 Flat
Washers supplied in Hardware Bag 7120-0310.
Position the Workstation in vehicle.
Depending on vehicle used and desired location, a center console or seat section may
need to be removed.
Check that the location chosen does not interfere with the proper operation of or cause
damage to - wiring, fuel or hydraulic lines, the exhaust system or drive train components
and vehicle controls like gear shift lever, airbag sensors or airbag deployment zone.
Using the Workstation or Adjustable Legs as a template, mark the mounting hole
location on the vehicle floor.
Drill mounting holes thru vehicle floor.
Hardware Bag 7120-0310 includes .38 x 1.50 grade 5 bolts, .38 flat washers, .38 lock
washers, .38-16 hex nuts and .38-16 rivet nuts for bolting to the vehicle floor.
Depending on the vehicle application and tools available, the supplied hardware may be
used or the customer may supply equivalent hardware as needed.
#3 - If drilling into the vehicle floor is not possible, the Workstation may also be
attached to a Gamber-Johnson MCS Long or Short Top Plate & Vehicle Specific Leg kit
(see Fig. 3).
Check with Gamber-Johnson if a Vehicle Leg kit is available for your application.
Leg kits are typically installed by removing driver and passenger seat bolts, inserting
leg kit between seat bracket and vehicle floor, reinstalling the seat bolts.
Specific instructions are supplied with each leg kit.
The Workstation is bolted to the Top Plate using .25-20 x 1.00 Carriage Bolts, .25 Lock
Washers, .25 Hex Nuts.