User's Manual

Installing CF19 Computer into the Dock
Step 1: Make sure the sliding door, located
on the bottom surface of the computer, has
been opened to expose the computers'
docking connector (fig 5). Make sure no
loose or foreign objects are on the surface
of the dock (fig 6).
Step 2: Unlock the latch if locked. Depress
the latch button to release the rear hooks
(fig7).
Step 3: Place the front edge of the computer
into the dock. Two notches on the front
edge of the computer case will fit onto the
two hooks along the front edge of the dock
(fig 8). Lower the back edge of the
computer down onto the docking connector.
Press down on the computer making sure
the computer case is flat in the dock.
Depress the latch to secure the computer.
Lock the latch if necessary (fig 9).
fig 5 fig 6
fig 7 fig 8
fig 9
fig 2
fig 1
fig 3
fig 4
Installation of the Power Jack:
Remove the #6-32unc x .1/4" long scew that attaches the Power Cable Cover to the outside of
the dock (fig 1). Attach the Power Cable Pull Strap (located in hardware bag) to the power
jack (fig 2). Plug the power jack into the input jack located on the port replicator board and
tuck the pull strap into the electrical box (fig 3). Replace the Power Cable Cover to hold the
power jack in place (fig 4).
3 0F 7
Remove
#6-32 x 1/4-in screw
& power cable cover