Manual

#2.- While lifting up on seat, place the base between the
seat frame and seat rail. Hold base at an angle and
insert long slots in base into out-board seat studs.
#3. - Push the in-board side of the base between
the seat frame and seat rail. Move the short
slots in the base, into the in-board seat studs.
#4. - Center the base between the seat rails.
Tighten in-board and out-board seat rail nuts.
#5. - Fasten the seat trim panel back to the seat frame
and reattach the seat adjustment lever.
In vehicles with heated seat option, connect the
wire harness to the heater switch.
Attach riser to base using supplied hardware.
Attach additional mounting equipment as required.
3 / 4
Base Installation 2006 thru 2010+ Vehicles
#1. - Move the passenger seat to back position.
Loosen the in-board and out-board seat rail nuts
with a 13mm wrench or socket, until the nuts are
even with the top of the seat studs.