Owner manual

ManualsBrandsGamber-Johnson ManualsComputer Accessories7160-0275

Plate, Universal Display Mount

INSTALLATION INSTRUCTIONS

Product Revision Form

7160-0275

Rev.C

INST-495

Printing Spec: PS-001

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

Product Mounting Disclaimer

Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage

of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson

products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

The Universal Display Mount Plate attaches to the Universal Display Mount (7160-0272,

7160-0273). Refer to the installation instructions for the Universal Display Mount for

additional installation instructions.

The Universal Display Mount Plate accepts displays with the following mounting patterns:

- 75mm VESA - Motorola MW800/MW810

- 100mm VESA - Gamber Johnson 4.09"X2.00" Accessories

- Data911 Displays (15.0" & 12.1") with 7160-0302

Installation:

1. Install the display to the Plate using manufacturer recommended hardware.

a. The plate can be installed forward, backwards or upside down depending on

mounting requirements.

2. Using the supplied 1/4-20 hardware, install the plate into the slots in the Universal Display

Mount. Per the picture below, the Plate can be installed using either set of mounting holes

3. The plate can be installed using either the upper or lower set of holes depending on the

desired final mounting position.

VESA 75mm

VESA 100mm

GAMBER

4.02" X 2"

MOTOROLA

MW800/810

1/4-20 UNC

HARDWARE

ROBOVU

ROBOVU FAN

CLEARANCE

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Product Revision Rev.C 7160-0275 Plate, Universal Display Mount Form INST-495 Printing Spec: PS-001 The Universal Display Mount Plate attaches to the Universal Display Mount (7160-0272, 7160-0273). Refer to the installation instructions for the Universal Display Mount for additional installation instructions. The Universal Display Mount Plate accepts displays with the following mounting patterns: - 75mm VESA - Motorola MW800/MW810 - 100mm VESA - Gamber Johnson 4.09"X2.
PAGE 2
DISPLAY AT HIGHEST DISPLAY AT LOWEST RoboVu Installation: 1. If the attached, remove the RoboVu Standoff Bracket (Item 1). 2. Install the Universal Diplay Mount Plate to the RoboVu Bracket using the 4 1/4-20 x .5" bolts and lock washers that were provided in the hardware bag. Note the Plate is installed upside down and the fan cutout lines up with the fan exhaust. 3. Mount the assembly (plate and RoboVu) into the Universal Display Mount. Note that the ears of Plate will face up.