User Manual

Adjustment
The 13-in Low Ergo console box is designed to allow adjustment of the front to back angle for the system. The box can
be tilt towards the front or back by up to fifteen degrees in each direction (Figure 3a and 3b).
The 13-in Low Ergo console box is designed to allow adjustment of the height of the system by up to 2.40-inches
(Figure 3c).
To adjust the tilt or height of the console box remove the appropriate socket head cap screws from each side of the box
and tilt or lift the box into the desired position. Secure the box position with the socket head cap screws that were
removed.
Forward Tilt
(a)
Rear Tilt
(b)
Horizontal
(c)
Figure 3: Tilt adjustment and height adjustment
Mounting Features
Motion Attachments
The 13-in Low Ergo console box will allow a user to mount any Gamber Johnson motion attachment to the top of the
box. It is recommended that all clevis attachments be mounted to the right most circle pattern to prevent interference
with the clevis knob and top of the console.
Electronics
The 13-in Low Ergo console box will allow a user to mount the Lind Ruggedized Shut Down Timer (Gamber PN
13791) or the 6 Circuit Power Distribution Blocks (Gamber PN 7160-0110 & PN 7160-0313) without drilling holes.
The 13-in Low Ergo console box has nine knockout locations to allow the use of several 12V automotive power sockets
(Gamber PN 7160-0063).
Figure 4: Motion Attachment and Electronics mounting points
SHEET 2 OF 3
Clevis Mount Location
12V Automotive Power Socket
Mount Location