User Manual

INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Rev.D
INST-513
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
Printing Spec: PS-001
VISOR MOUNT,2 UNIT,SINGLE SIDE ATTACHMENT
7160-0312, 7160-0373
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
TheVisorMount,2Unit,S ingleSideAttachmentprovidestheuserwiththecapabilitytosecureamobile
cameraandamonitortothepassengersidevisor.EachsystemincludestwoMax
3
allaxisknucklesthat
allowtheusertoorientthemonitorandcamera inseveralpositions.Inaddition,thesystemisequipped
withtworubberpadsandseveralmountingholestoensurethecameraandmonitorareheldsecureand
firm.
ToolsNeeded MaterialNeeded
5/64‐inHexwrench(Allenwrench) #10Selfdrillingscrew
3/16‐inHexwrench(Allenwrench)
 #8x1.00sheetmetalscrewfor2010+Charger

Installation
1. Removethepassengersidevisorretainerclipnearthecenterofthevehicle.Refertofigure1.
2. SecuretheVisorMounttotheheadliner usingthevisorretainerandtwoadditionalselftapping
fasteners.
a. Selftappingfasteners arenotsup plied.
b. Caution:Selftappingfastenersthataretoo
longmaygothroughroofofvehicle.
3. Securethecameratothefrontcamerabracketusing(2)¼‐20x.50socketbuttonheadcapscrew,
(2)¼‐inlockwasher,and(4)¼‐innylonflatwashers.Refertofigure2.
4. Securethemonitortothemonitor
bracketusing har dwaresuppliedbymonitormanufacturer.
Refertofigure3forholepatternsavailable.
5. Positionthecameraandmonitorasdesired.
6. Inserttwoandtightenall#10‐32socketheadsetscrewstolocktheMax
3
knucklesinplace .Referto
figure2.

Sheet 1 of 2
Figure1.SecureVisorMountwithpassengersidevisorretainer.