User Manual

Console installation
1. Unpack console and remove Top Plate, Spreader Plate and Shifter Gate Plate.
2. Slide console partially into vehicle.
3. Place shifter assembly into console.
4. Bolt shifter assembly into console using OEM hardware.
5. Loosely bolt console box into vehicle using OEM hardware at front and rear of
box.
6. Reinstall Spreader Plate and Top Plate.
7. Tighten console box mounting hardware.
8. Route main harness through box and plug in shifter interlock harness.
9. Install storage bin/low range switch into cutout in Shifter Gate Plate.
10. Using needle nose pliers, carefully pry out the spring clips on the storage
bin/low range switch to secure it into the Shifter Gate Plate (Fig 8).
11. Install Shifter Gate Plate into console by applying a proper length of the
provided Dual Lock ™ reclosable fastener to the back side of the plate and
pressing into place at front of console.
12. Place shifter knob chrome ring and shifter knob onto shifter pole.
13. Reinstall the shifter retaining clip into shifter knob and snap chrome ring into
place.
14. Install Dash Fill Extensions using the provided hardware.
15. Reconnect vehicle power and test movement of shifter through the Shifter
Gate Plate.
Fig 7 - Harness and Shifter Removed Fig 8 - Low Range Spring Clips