User Manual

installing.
install equipment or route wiring or cords in the deployment path of any air bag.
WARNING
: Failure to follow all safety precautions and instructions may result in property
DO NOT
PRE-INSTALLATION RECOMMENDATOINS
Test the docking station to ensure that it is working properly.
Safety is dependent on the proper installation and servicing of this docking station. It is
Opening the docking station will void the product warranty.docking station.
After installation:
sparks resulting in electrical fires or flying molten metal.
If wiring is shorted to the frame, high current conductors can cause hazardous
CAUTION:
anything that could be damaged.
When drilling into the vehicle, DO make sure that both sides of the surface are clear of
IMPORTANT SAFETY INFORMATION FOR INSTALLERS
important to read and follow all instructions before installing this product.
To properly install a Gamber-Johnson docking station you must have a good understanding of
automotive electrical procedures and systems, along with proficiency in the installation and
service of aftermarket vehicle equipment.
There are no adjustments required at any time of the electrical components within the
File these instructions in a safe place and refer to them when performing maintenance or re-
damage, serious injury, or death.
During Installation:
DO NOT connect this docking station to the vehicle battery until:
All other electrical connections are made1.
Mounting of all components is complete2.
Verification that no shorts exist in the entire system3.
Conduct a "Bench Test"
Gamber-Johnson strongly advises a "bench test" be conducted to verify all
electronic and software issues are resolved prior to installation:
Make sure the computer is operational by itself.1.
Insert computer into the docking station and verify that the computer is 2.
operating in the dock.
Interconnect entire assembly and verify start-up of all components, 3.
including other equipment (printers, modems, scanners, etc.)
Gamber-Johnson recommends positioning of all mounts and equipment in the
vehicle prior to the actual install to verify that mounting locations are safe and
practical.