User Guide

Set up your PlayStation®2 computer entertainment system according to the
instructions in its Instruction Manual. Make sure the MAIN POWER switch (located
on the back of the console) is turned on. Press the RESET button. When the power
indicator lights up, press the open button and the disc tray will open. Place the
SOCOM II: U.S. Navy SEALs disc on the disc tray with the label side facing up. Press
the open button again and the disc tray will close. Attach game controllers and
other peripherals, as appropriate. Follow on-screen instructions and refer to this
manual for information on using the software.
NETWORK ADAPTOR (ETHERNET/MODEM) (FOR PLAYSTATION®2)
In order to play SOCOM II: U.S. Navy SEALs online, you must have installed a
Network Adaptor (Ethernet/Modem) (for PlayStation
®2) on your PlayStation 2
computer entertainment system before playing. Set up the Network Adaptor
according to the instructions included in its packaging.
Caution: Unplug the AC power cord on your PlayStation 2 computer
entertainment system before adding any networking equipment to the system.
Note: SOCOM II: U.S. Navy SEALs must be played over a broadband internet
connection (DSL, cable modem, or higher speeds).
MEMORY CARDS
A memory card is required to play SOCOM II: U.S. Navy SEALs both online and
offline. Before playing online, a valid Network Configuration must be saved to the
memory card using either the Network Adaptor Start-Up Disc or the SOCOM II
Network Configuration utility.
To save game settings and progress, insert a memory card (8MB) (for PlayStation
®2)
into the MEMORY CARD slot 1 of your PlayStation 2 computer entertainment
system. You can load saved SOCOM II: U.S. Navy SEALs game data from the same
card or any memory card containing previously saved data. See “Creating a Network
Configuration” on page 27.
HEADSET (OPTIONAL)
The SOCOM headset or USB headset (for PlayStation®2) allows you to issue voice
commands to fellow SEALs and talk with teammates during online games. Connect
the headset to either of the USB (Universal Serial Bus) connectors located on the
front of your PlayStation 2 computer entertainment system with the USB symbol on
the plug facing UP.
SETTING UP YOUR CONSOLE
45
2
MEMORY CARD slot 1
MEMORY CARD slot 2
USB connector
S400 i.LINK connector

controller port 1
controller port 2
disc tray
RESET button
(OPEN) button
SOCOM2 manual_rev1.qxp 10/30/03 4:22 PM Page 4