User Guide

11
Run to
SEALs run to a designated position.
Lead To
Use this command to decide whether Able or Bravo will take point when moving
from one objective to the next. Bravo unit leads only if you are within a certain
distance of them. If you are outside that distance they will wait until you are in
range to begin leading again. Able teammate Jester will take the lead but change to
“Following” if you drift too far from him.
Attack To
Designate who will advance to a specified position, while firing at any enemy
encountered. If using the crosshairs to point at an enemy, your team will attempt
a shot instantly.
Stealth To
Advance as quietly as possible in a prone position while taking advantage of the
terrain, structures or foliage to minimize the chance of discovery.
Hold Position
Hold position until commanded otherwise.
Regroup
The team will move to your position.
TACTICAL COMMANDS
Fire At Will
SEALs will fire on any enemy encountered.
Deploy
Use explosive weapons. If your SEALs are equipped with grenades, C-4 or satchel
charges, they will respond.
Cover Target
Give the command to cover a specific point. Enemies entering that zone will be
fired upon. Place your crosshairs on the location and issue the command. Your
SEALs must have visual contact on the specified area to carry out this order.
Hold Fire
Hold fire until you countermand the order.
Overwatch
Teammates will cover a designated area, calling out any enemies that they see.
Place your crosshairs on the location and issue the command.
Frag/Clear
Deploy a fragmentation grenade and clear the breached area.
10
MOVEMENT AND POSITION COMMANDS
Use movement and position commands to specify exact positions or map coordinates.
Using the Crosshairs as a Pointer
Use the crosshairs to send team member(s) to a position
or alert them to something at a specific location.
Position the crosshairs on the point of interest and
issue your command finishing with the word
“Crosshairs.” For example, place your crosshairs over
an enemy and issue the command “BRAVO…ATTACK
TO…CROSSHAIRS.” Bravo will move into position
and attack the enemy.
Note: Your crosshairs do not have to be on an
enemy to execute an “ATTACK TO” command.
Your crosshairs can be on a door, building or
even the ground, and your teammates will move to that position,
attacking any targets of opportunity they see.
Using Nav Points
Nav Points are map coordinates marking key positions in your op area and are created
prior to insertion. They are always Charlie, Delta, Echo, Foxtrot, Juliet, Romeo, Whisky,
X-Ray or Zulu. View them on the Tactical Map display by pressing
q and using the
analog sticks to navigate and zoom the map. See “TacMap and Mission Objectives” for
detailed instructions on using the Tactical Map.
Note: Moving to a specific point during a mission may be a required objective.
Follow
You take point and the team follows behind you and assumes your body position.
For example, if you advance in prone position, they will too.
6
THE COMMANDS
(SINGLE PLAYER)
SOCOM2 manual_rev1.qxp 10/30/03 4:23 PM Page 10