Assembly Instructions

ASSEMBLY INSTRUCTIONS
BACKYARD PELLET TRAP
WARNING: THIS PELLET TRAP IS DESIGNED FOR USE WITH LEAD AIRGUN
PELLETS ONLY. DO NOT USE BBS. BBS WILL REBOUND AND RICOCHET AND
CAN CAUSE PERMANENET INJURY, PARTICULARLY TO THE EYE.
WARNING: BE SURE THE AREA AROUND THE TARGET IS CLEAR AND SAFE
IN CASE THE SHOOTER SHOULD MISS THE TARGET.
WARNING: ALWAYS WEAR PROTECTIVE SHOOTING GLASSES.
CAUTION: DO NOT USE WITH TARGET CLOSER THAN FIFTEEN (15) FEET
TO THE SHOOTER BECAUSE PELLETS COULD FRAGMENT AND HIT THE
SHOOTER.
1
2
4
4
4
4
4
3
3
5
6
©2007 GAMO USA Corp. , 39110 SW 47th Ave.
Suite 914., Ft. Lauderdale, FL USA
Printed in China • GIS-49
visit us at www.gamousa.com
3) Repeat step one.
4) Repeat step two. Attaching
all four sides together.
5) Slide fully assembled
cone trap into the base.
6) Insert paper target into slots at the front of
the cone trap. You are now ready to shoot.
1) Align the steel plate with
the holes punched in it
with the steel plate with
the screws in it.
2) Unscrew the caps of the
screw. Place the steel
plate with the holes over
the screws. Tighten the
caps.
GIS-49 Cone trap assembly instr 12/5/07 5:40 PM Page 1