User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. General Information
- 3. Mounting
- 3.1 Definition of the Door Hinge (Right or Left Door)
- 3.2 Metallic and Non-Metallic Doors
- 3.3 Dimension Diagrams for Mounting
- 3.4 Door Status Contact
- 3.5 Mounting in Lockers with Non-Metallic Doors
- 3.6 Mounting in Lockers with Metallic Doors
- 3.7 Points to be observed during Installation
- 3.8 Test Installation
- 3.9 Replacement after a Burglary Attempt
- 3.10 Installation of the GAT NET.Controller M/S 7000
- 4. Electrical Connection
- 5. Configuration And Operation
- 5.1 Antenna Adjustment of the GAT NET.Lock 7000
- 5.2 Locker Operation by the Visitor
- 5.3 Restart a Controller GAT NET.Controller S 7000 or GAT NET.Controller M 7000
- 5.4 Delete Configuration Parameters of a Controller (= Reset to Default Settings)
- 5.5 Status Information for the GAT NET.Controller S 7000 and GAT NET.Controller M 7000
- 5.6 GAT Relaxx - Operation Software for GAT NET.Lock 7000 System
- 6. Technical Data
GAT NET.Lock 7000 System
Electrical Connection
www.gantner.com
HB_GAT-NETLOCK7000--US_33
27
4. ELECTRICAL CONNECTION
This chapter describes the electrical connections required between the GAT NET.Lock 7000 and the GAT
NET.Controller S 7000 and GAT NET.Controller M 7000 control units.
Electrical connections must only be done in a powerless state and only by trained and specialised person-
nel.
4.1 System Structure
The GAT NET.Lock 7000 is always connected to the GAT NET.Controller S 7000 slave controller. The slave con-
trollers are in turn networkable via the serial RS 485 interface and are connected to a GAT NET.Controller M 7000
master controller. The master controllers are connected via Ethernet to a host computer or server.
Figure 4.1 - GAT NET.Lock 7000 system structure