User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. General Information
- 3. Mounting
- 3.1 Definition of the Door Hinge (Right or Left Door)
- 3.2 Metallic and Non-Metallic Doors
- 3.3 Dimension Diagrams for Mounting
- 3.4 Door Status Contact
- 3.5 Mounting in Lockers with Non-Metallic Doors
- 3.6 Mounting in Lockers with Metallic Doors
- 3.7 Points to be observed during Installation
- 3.8 Test Installation
- 3.9 Replacement after a Burglary Attempt
- 3.10 Installation of the GAT NET.Controller M/S 7000
- 4. Electrical Connection
- 5. Configuration And Operation
- 5.1 Antenna Adjustment of the GAT NET.Lock 7000
- 5.2 Locker Operation by the Visitor
- 5.3 Restart a Controller GAT NET.Controller S 7000 or GAT NET.Controller M 7000
- 5.4 Delete Configuration Parameters of a Controller (= Reset to Default Settings)
- 5.5 Status Information for the GAT NET.Controller S 7000 and GAT NET.Controller M 7000
- 5.6 GAT Relaxx - Operation Software for GAT NET.Lock 7000 System
- 6. Technical Data
GAT NET.Lock 7000 System
Electrical Connection
32
HB_GAT-NETLOCK7000--US_33
www.gantner.com
Figure 4.9 - Examples for power supply
4.3.4 LED Signals and Buttons
For the display of the operating state and to start certain functions various LED indicators and buttons are provided
on the GAT NET.Controller S 7000.
Figure 4.10 - LEDs and buttons provided on the GAT NET.Controller S 7000
LEDs
- RS 485 IN (yellow): The connection with the master controller has been established.
- RS 485 IN (green): RS 485 communication is active.
- LED 1 (blue): Lock activated/controlled.
- LED 2 (green/red): See "5.5. Status Information for the GAT NET.Controller S 7000 and GAT NET.Controller M
7000".
Buttons
- RESET: 1. See "5.3. Restart a Controller GAT NET.Controller S 7000 or GAT NET.Controller M 7000"
2. See "5.4. Delete Configuration Parameters of a Controller (= Reset to Default Settings) "
- MODE: See "5.1 Antenna Adjustment of the GAT NET.Lock 7000"
Yellow LED
Green LED