User's Manual

GAT Access 6100, GAT Access 6100 F BIO, GAT Access 6100 F Enrollment Station, GAT TimeAxx 6150
www.gantner.com HB_GAT-ACCESS6100--EN_12 3
General Warning and Safety Instructions
Dear customer,
We congratulate you on having selected a product (appliance or software) from GANTNER Electronic GmbH. Our aim is to ensure that our
product operates with safety and to your complete satisfaction. To achieve this aim we take this opportunity to familiarize you with the
following guidelines:
1. Installation, commissioning, operation and maintenance of the purchased product must be carried out in accordance with the
instructions, i.e., in accordance with the technical conditions of operation as described in the corresponding product documentation.
2. Before installation, commissioning, operation or maintenance it is therefore essential that you read the corresponding chapter of this
manual and observe its instructions.
3. If there are still some points on which you are not entirely clear, please do not take a chance. All queries can be clarified by your
Gantner company representative, or by ringing the GANTNER Electronic GmbH hotline.
4. Where not otherwise specifically documented, the appropriate installation, commissioning, operation and maintenance of the product
is the customer’s responsibility.
5. Directly on receipt of the goods, inspect both the packaging and the product itself for any signs of damage. Additionally, check that
the delivery is complete and includes all accessories, documentation, auxiliary devices, etc.
6. If the packaging or product has been damaged in transport, or should you suspect that it may have a fault, the product must not be
put into service. In this case, contact your Gantner company representative. They will make every effort to resolve the problem as
quickly as possible.
7. Installation, commissioning and servicing of our appliances must only be carried out by suitably trained personnel. In particular,
electrical connections must only be made by correspondingly qualified specialists. Here, the appropriate installation provisions in accordance
with the relevant national Electrical Engineers construction regulations (e.g., ÖVE, [Austrian] VDE, [German]...) must be observed.
8. Where not otherwise stated, installation and maintenance work on our appliances must be carried out when disconnected from the
power supply. This applies in particular to appliances that are normally supplied by low-voltage current.
9. It is prohibited to alter the device or to remove protective shields and covers.
10. Do not attempt yourself to repair an appliance after a defect, failure or damage, or to put it back into operation again. In such cases,
it is essential you contact either your Gantner company representative or the GANTNER Electronic GmbH hotline.
11. GANTNER Electronic GmbH accepts no responsibility for any injuries or damage caused as a result of improper use.
12. Although every care is taken and we are continuously aiming for improvement, we cannot completely exclude the possibility of errors
appearing in our documentation. GANTNER Electronic GmbH therefore accepts no responsibility for the completeness or the accuracy of
this manual. The right is reserved to make alterations, and we may carry out alterations at any time without giving prior notice.
13. Should you discover any fault with the product or in its accompanying documentation, or have any suggestions for improvement, you
may confidently approach either your Gantner company representative or GANTNER Electronic GmbH directly.
14. We especially look forward to hearing from you if you just want to tell us that everything is functioning perfectly.
We wish you a successful experience with our product and look forward to welcoming you again as a customer soon.
Contact address / manufacturer:
GANTNER Electronic GmbH
Montafonerstrasse 8
A - 6780 Schruns/Austria
Tel.: [phone] - 0
Fax: [phone] - 8000
Email: [e-mail]
Website: www.gantner.com