User's Manual

GAT Access 6100, GAT Access 6100 F BIO, GAT Access 6100 F Enrollment Station, GAT TimeAxx 6150
Start-Up and Configuration
www.gantner.com HB_GAT-ACCESS6100--EN_12 39
The configuration settings of the GAT Access 6100 are organised into several categories. The directory on the left
(1) lists the different configuration categories. Click on a category and the settings for this category can be viewed
and adjusted in the field to the right (2). A short description of the setting is shown at the bottom of the window (3).
An overview of all the configuration settings is available in Table 4.1.
Note: A more detailed description of all available settings can be found in the GAT Config Manager manual.
4.3.2 Project Configuration
Complete the following steps to configure the GAT Access 6100 via a project in GAT Config Manager.
 Click on the “Open Project” icon (1 in Figure 4.17) to find an existing project. Alternatively, click on the “Create
Project” icon (2 in Figure 4.17) to start a new project.
Figure 4.17 – GAT Config Manager - project setup
 Once a project is established, click on the “Scan Device” icon (1 in Figure 4.18).
o The software scans the network and displays a list of all connected GANTNER devices.
 Select your GAT Access 6100 from the list. Use device details such as the IP and MAC address to identify the
correct device.
o The selected device is highlighted in blue as shown in Figure 4.18.
 Click on “OK” (2 in Figure 4.18).
o The selected device is added to the “Devices” list (3 in Figure 4.18).