User's Manual

GAT LOCK 6010 F
Installation
www.gantner.com HB_GAT-LOCK6010F--US_16 21
Figure 2.8 – Drill hole plan for right-hand locker door
Note re. A :
Care must be taken during installation to make sure that the GAT Lock 6010 F
does not brush against the body of the locker when the door is opened. The
distance of 4 mm (0.16 inch) given between the lock housing and the body of the
locker is valid for a distance door pivot <-> centre of the button greater 240 mm
(9.45 inch) and a distance door pivot <-> lock base surface (installation surface)
smaller 20 mm (0.79 inch) (also negative). In the case of doors that do not adhere
to these measurements or with doors with a changeable pivot (depending on the
kind of hinge used), the distance between the lock and the body of the locker has
to be enlarged or recalculated.
Note re. B :
To increase break-in protection, a safety bolt has to be mounted on the body of
the locker which enters the door leaf when the door is closed.