User's Manual

GAT LOCK 6010 F
Start-Up
www.gantner.com HB_GAT-LOCK6010F--US_16 27
4. START-UP
4.1. Inserting the Battery
Before putting the GAT Lock 6010 F into operation, make sure there is a battery
inserted in the battery compartment. Otherwise insert a battery (see "5.1.
Changing the Battery").
The batteries must be inserted into the GAT Lock 6010 F after the
transportation, i.e. after the lockers are installed on site!
4.2. Configuration
Each GAT Lock 6010 F can be configured individually using a configuration
device (PC, laptop). This configuration is a one-off operation. During
configuration, the following data are imported into the GAT Lock 6010 F:
 SiteKey
 Sub-site number
 Locker number
 GAT Lock 6010 F mode ("Free Locker", "Free Locker with UID", "Personal
Locker with Programming Card" or "Personal Locker with Expiry Date" mode,
see "4.2 Operation Modes")
 Free Locker: Sector number of the data on the data carrier and locking time (for
"limited duration of use" function).
 Date and time (set automatically)
 Unique numbers of the master data carriers
Note: The master data carriers can also be directly programmed into a lock.
Because of efficiency reasons, it is recommended to programm the data
carriers into the locks with the use of a PC-software (e.g. GAT Config Manager).
After the configuration of the first lock, carry out a test whether the master data
carriers and the normal data carriers are read correctly.
The GAT Lock 6010 F doesn’t set the daylight saving time automatically! This
has to be considered by the evaluation of the bookings and also by the
authorisation of the data carriers with expiry date!