User's Manual

GAT LOCK 6010 F
Operation
www.gantner.com HB_GAT-LOCK6010F--US_16 33
Locking and Unlocking Lockers
1.) Hold the locker door pressed shut with one hand.
2.) Press the button of the GAT Lock 6010 F as far as it will go using the
MIFARE
®
data carrier and keep it pressed for about 1 second.
 The information on the data carrier will be read.
3.) a) If the MIFARE
®
data carrier is valid, the LED will light up green briefly and
the action (locking, unlocking) is carried out. With the duration of use
functionality the time on the data carrier is checked and the current time
is written onto the data carrier.
b) If the MIFARE
®
data carrier is invalid, the LED will light up red briefly and
the GAT Lock 6010 F is switched off again without an action being carried
out.
 A possible reason for that can be that another locker has already been
locked with the used data carrier. In this case the other locker must
first be unlocked before the data carrier can be used at the new locker.
Another reason can be that the duration of use of the locker is
exceeded and therefore the locker cannot be opened anymore. In this
case the data carrier must be recoded with a write station.
4.) Release the locker door.
The data carrier must be kept in front of the button until the locking resp.
unlocking is done. Don’t remove the data carrier too early.