User's Manual

GAT LOCK 6010 F
Operation
www.gantner.com HB_GAT-LOCK6010F--US_16 37
5.2.4. Personal Locker Mode with Expiry Date
At the check-in the customer receives a MIFARE data carrier with GANTNER
data blocks. The site number and sub-site number will be written to the general
data block and the customer’s personnel locker number together with the expiry
date ("valid from" and "valid to") will be written to the locker data block of the data
carrier. Furthermore an index value will be written to that locker data block. The
"valid from" date must always be valid, i.e. newer or equal to the date stored in
the used locker lock.
On first identification at a locker the expiry date ("valid to" date) and the current
index value of the data carrier will be stored in the lock. Then the customer can
lock and unlock his locker any time, starting at the "valid from" date, and as long
as the expiry date is not reached or exceeded. Note that with firmware version
3.3 and later the expiry date and the index value are also written to the lock when
reading a data carrier while the locker door is locked.
Pay attention that the GAT Lock 6010 F doesn't set the daylight saving
time automatically. This must be considered for evaluation of events and
for authorising data carriers with expiry date.
For the data carriers of the authorised persons the following conditions must be
fulfilled:
- The same locker number must be stored on the data carriers
- Same expiry date
- Same index value
If one of these data carriers is then used at the locker for the first time, the expiry
date and the index value of the data carrier gets saved in the locker.
Locking and Unlocking Lockers
1.) Hold the locker door pressed shut with one hand.
2.) Press the button of the GAT Lock 6010 F as far as it will go using the MIFARE
data carrier and keep it pressed for about 1 second.
 The information on the data carrier will be read. The locker number of the data
carrier has to correspond with the locker number in the lock.