User's Manual

GAT LOCK 6010 F
4 HB_GAT-LOCK6010F--US_16 www.gantner.com
General warning and safety instructions:
Dear customer,
we congratulate you on having selected a product (device resp. software) of GANTNER Electronic
GmbH. So that our product functions in your installation with safety and to your complete satisfaction,
we take this opportunity to familiarise you with the following ground rules:
1. Installation, commissioning, operation and maintenance of the product purchased must be carried
out in accordance with instructions, i.e. in accordance with the technical conditions of operation, as
described in the corresponding product documentation.
2. Before either installation, commissioning, operation or maintenance it is therefore essential that you
read the corresponding chapter of this manual and observe its instructions.
3. If there are still some points on which you are not entirely clear, please do not take a chance, but
ask the customer adviser responsible for you, or ring the GANTNER Electronic GmbH hotline.
4. Where not otherwise specifically laid down, appropriate installation, commissioning, operation and
maintenance of the product is the customer’s responsibility.
5. Directly on receipt of the goods, inspect both the packaging and the device resp. data carrier itself
for any signs of damage. Also check that the delivery is complete (-> accessories, documentation,
auxiliary devices, etc.).
6. If the packaging has been damaged in transport or should you suspect that it has been damaged or
that it may have a fault, the product must not be put into service. In this case, contact your customer
advisor. He will make every effort to resolve the problem as quickly as possible.
7. Installation, commissioning and servicing of our appliances must only be carried out by suitably
trained personnel. In particular, electrical connections may only be made by correspondingly
qualified specialists. Here, the appropriate installation provisions in accordance with the relative
national Electrical Engineers construction regulations (e.g. ÖVE, [Austrian] VDE, [German]...) must
be observed.
8. Where not otherwise stated, installation and maintenance work on our appliances is exclusively to
be carried out when disconnected from the power supply. This applies in particular to appliances
which are normally supplied by low-tension current.
9. It is prohibited to make alterations to the appliances or to remove protective shields and covers.
10. Do not attempt yourself to repair an appliance after a defect, failure or damage, or to put it back into
operation again. In such cases, it is essential you contact either your customer adviser or the
GANTNER Electronic GmbH hotline. We will make every effort to resolve the problem as quickly as
possible.
11. GANTNER Electronic GmbH accepts no responsibility for any injuries or damage caused as a result
of improper use.
!