Installation Instructions

GL7p - Battery-powered, door-mounted electronic locker lock GL7p
Installation
28 HB_GL7p--EN_12 www.gantner.com
Vertical mounting Horizontal mounting, right door Horizontal mounting, left door
► Tighten the lock nut (8) so that the latch is firmly attached (torque max. 1.5 Nm).
► Secure the anti-rotation (tightening torque max. 1.0 Nm) using a screw suitable for the door thickness and, if
necessary, the spacer sleeve and/or washer:
- For door thicknesses 1 to 5 mm: supplied screw + spacer sleeve
- For door thicknesses 5 to 10 mm: KA35x20 screw + spacer sleeve
- For door thicknesses greater than 10 mm: supplied washer + KA35 screw suitable for the door thickness or
3.5 mm tapping screws
Door thickness > 9.5 mm Door thickness < 9.5 mm
Figure 3.9 – Side view of the GL7p after installation with different door thicknesses
► Finally, ensure that the latch can be closed and opened without resistance (press the button).
► When the locker is locked, ensure that the door is held in the closed position by the latch without creating a
door gap.
See chapter "4 COMMISSIONING" for information on how to insert the batteries and commission the GL7p.