Installation Instructions
Table Of Contents
- 1 INTRODUCTION
- 2 GENERAL INFORMATION
- 3 INSTALLATION
- 4 COMMISSIONING
- 5 CONFIGURATION
- 6 OPERATION
- 7 CLEANING AND MAINTENANCE
- 8 TECHNICAL DATA
GL7p - Battery-powered, door-mounted electronic locker lock GL7p
Commissioning
www.gantner.com
HB_GL7p--EN_12
35
► Now press the button of the GL7p to activate configuration mode.
a) If the lock has not been configured yet (default setting), the GL7p only has to be connected.
b) If the lock has already been configured at least once, i.e., the default setting has been deactivated, the
button must be pressed with the SERVICE data carrier from the Basic Set.
o The GL7p enters into configuration mode and the LED slowly pulses green to indicate this state.
► In GAT Config Manager, click on “Configure” to open the configuration settings.
Further information regarding configuring the GL7p is available in "5. CONFIGURATION".