Installation Instructions

GL7p - Battery-powered, door-mounted electronic locker lock GL7p
Operation
56 HB_GL7p--EN_12 www.gantner.com
6.3.4 Personal Locker Programming Card Mode
For lockers operating in “personal locker programming card” mode, up to 32 data carriers and/or 32 PIN codes per
GL7p can be authorized for use. These 32 data carriers and/or 32 PIN codes can be used with the locker as often
as required and share the same authorization access, e.g., for use as family cards.
The data carriers are authorized for use with the personal locker using the PROGRAM data carrier (included in the
GAT ECO.Basic Set, see section “6.4 GAT ECO.Basic Set FD”).
Authorizing data carriers
► Close the locker door.
► Press the button of the GL7p in using the PROGRAM data carrier for approximately 1 second.
o The information on the data carrier is read and the LED flashes green briefly.
► The GL7p enters into programming mode.
o The LED flashes red until the PROGRAM data carrier is removed. As soon as the PROGRAM data
carrier has been removed, the LED flashes red/green and the lock is ready to program data carriers.
► Within 5 seconds, hold the data carrier being authorized in front of the GL7p button (the button does not need
to be pressed).
a) Successful authorization: The LED flashes green for approximately 3 seconds. When the data carrier is
removed, the LED flashes red/green alternately again and another data carrier can be authorized in the
same way. Repeat this process until all the data carriers are authorized.
b) Unsuccessful authorization: The LED flashes red and the GL7p switches off. Possible reasons for this
include:
- The maximum of 32 data carriers are already authorized in the GL7p.
- The data carrier could not be read correctly, e.g., because the data carrier is damaged.
► You can repeat the last step using different data carriers to program these data carriers successively. To do
this, each data carrier being authorized must be held in front of the GL7p button within 5 seconds after
removing the previous data carrier. If you wait longer than 5 seconds, the reading process is terminated, and
the read data carriers are saved in the lock.
Authorizing PIN codes
► Close the locker door.
► Press the button of the GL7p in using the PROGRAM data carrier for approximately 1 second.
o The information on the data carrier is read and the LED flashes green briefly.
► The GL7p enters into programming mode.
o The LED flashes red until the PROGRAM data carrier is removed. As soon as the PROGRAM data
carrier has been removed, the LED flashes red/green and the lock is ready to program data carriers.
► Within 5 seconds, enter the PIN code being authorized and confirm with the OK key (✓) or by pressing the push
button.
a) Successful authorization: The LED flashes green for approximately 3 seconds. When the data carrier is
removed, the LED flashes red/green alternately again and another PIN code can be authorized in the same
way. Repeat this process until all the PIN codes are authorized.
b) Unsuccessful authorization: The LED flashes red 3 times and the GL7p switches off. Possible reasons for
this include:
- The maximum of 32 PIN codes are already authorized in the GL7p.
- The PIN code was not correctly entered, e.g., the PIN code was too short or too long or an invalid PIN code
was entered.