Installation Instructions

GL7p - Battery-powered, door-mounted electronic locker lock
6 HB_GL7p--EN_12 www.gantner.com
The GL7p was developed and fabricated under the quality management standard ISO 9001 and GANTNER Electronic GmbH is
also certified according to standard ISO 14001.
This product is in conformity with the following EC directives, including all applicable amendments:
- 2014/53/EU (Radio Equipment Directive)
The complete text of the CE Declaration of Conformity is available on the following internet link:
http://www.gantner.com/en/produkte/downloads-GL7p_jQ690dP3B6
GANTNER is committed to meeting or exceeding the requirements of the RoHS directive (2011/65/EU). The RoHS
directive requires that manufacturers eliminate or minimize the use of lead, mercury, hexavalent chromium,
cadmium, polybrominated biphenyls and polybrominated diphenyl ethers in electrical and electronic equipment sold
in the EU after July 1, 2006.
FCC INFORMATION (U.S.A.)
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that of which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Warning Statement:
[Any] changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Comliance Statement (GL7p.0500, GL7p.150x):
Compliance Statement (GL7p.2500, GL7p.350x):
The GL7p.2xxx and GL7p.3xxx contain a wireless module. For those modules the following applies:
FCC Radio Frequency Exposure:
WARNING: To comply with RF exposure limits the users must keep at least 20 cm separation distance from the
device, except during the identification and operation process at the device (e.g. PIN-code input), which must be
performed as described in this manual.
FCC ID: NC4-GEA1190118A
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device must not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
FCC ID: NC4-GEA1190126A
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device must not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This device contains
FCC ID: QWO-QS9322PLCS
IC: 4460A-QS9322PLCS