Installation Instructions
GAT NET.Lock 7020 System
Introduction
www.gantner.com
HB_GAT-NETLOCK7020--EN_12
11
1.
INTRODUCTION
1.1
About this Manual
This manual contains all the necessary information required to install GAT NET.Lock 7020 RFID locks into
lockers/depots. Operating instructions for the end user are also fully explained. In order to use GAT NET.Lock 7020
locks, a GAT NET.Controller S 7020 sub controller, a GAT NET.Controller M 7020 master controller, and the
associated network and power cabling are required.
In addition to these hardware requirements, PC software (e.g., GAT Relaxx) is required to firstly configure the
components then to control and monitor the locker system and the RFID data carriers used to operate the locks.
General information on the installation and operation of these system parts is also included in this manual. There is a
separate installation and user manual available in addition to an integrated help function for detailed information on
GAT Relaxx.
1.2
Chapter Overview
In chapter 2 "GENERAL INFORMATION", general information about the GAT NET.Lock 7020 system as well as an
overview of the various system parts with order information can be found.
Chapter 3 "INSTALLATION" includes instructions on how the GAT NET.Lock 7020 locks are installed into the lockers.
Here the mounting procedure of the locks and bolt sets is described in addition to all important measurements and
installation information. Because there are many different types of lockers available, the mounting procedure is
described generally and not for a specific type of locker.
Chapter 4 "ELECTRICAL CONNECTIONS" describes how the GAT NET.Lock 7020 locks and controllers are
connected to each other and connected to their power supplies. Also found here is information about the requirements
and installation of the network connection cables.
Chapter 5 "CONFIGURATION AND OPERATION" describes the operation of the GAT NET.Lock 7020 by a
user/visitor within a facility. Instructions for antenna adjustment and the resetting and deleting of configuration
parameters in the controllers are also explained. The visual and acoustic signaling of the GAT NET.Lock 7020 and
controllers are also described here. An overview of the GAT Relaxx configuration software is also included in this
chapter.
Available in chapter “6 CLEANING AND MAINTENANCE" is all the information required to carry out functional testing
of the GAT NET.Lock 7020 system as well as how to clean and maintain the components.
Chapter 7 "TECHNICAL DATA" contains the necessary technical information for the GAT NET.Lock 7020 locks and
the GAT NET.Controller S 7020 and M 7020 controllers.
1.3
Contact & Enquiries
If you have any questions concerning the GAT NET.Lock 7020, please contact your local sales partner or directly with
one of the GANTNER branch offices. The contact details of the branch offices are provided on the cover of this
manual.