Installation Instructions

GAT NET.Lock 7020 System
Cleaning and Maintenance
58 HB_GAT-NETLOCK7020--EN_12 www.gantner.com
Frequency
- After every 1000 locking operations, or,
- If the locking function of a locker door is impaired.
Instructions
► Press the locker door shut.
o The door shackle must enter the corresponding opening in the lock centrally without touching the
opening. The door must close shut without increased effort. Readjust the door (see below) if these
conditions are not met.
o The GAT Lock Bolt Set must touch the front of the door lock when the door is pressed shut. Readjust the
door (see below) if it does not.
► While pressing the locker door shut, hold an authorized data carrier near the reading field on the door.
o The locker door must lock. If it does not, check that the data carrier authorization is valid and also check
that the cabling / communication between the lock, controller, and control software (e.g., GAT Relaxx) on
the server is functioning.
► While the locker door is locked, press the door in slightly with the fingers several times.
o The door must be able to be pressed in slightly, one or two millimeters, and then return by itself. If the
door gets jammed or is stiff, it must be readjusted (see below).
► While the locker door is locked, firmly push the door with the palm of the hand (do not damage the door).
o The alarm must not be triggered.
► Hold an authorized data carrier a distance of approximately 1 cm in front of the locker door.
o The locker door must unlock and spring open independently. If the door does not spring open by itself,
the door must be readjusted (see below). If the data carrier is not read at this distance, the RFID reading
range is possibly too small and may benefit from being calibrated using GAT Relaxx software (see the
GAT Relaxx user manual).
Adjusting the locker door and door bolt
If a problem, as described previously in “Instructions”, occurs while opening or closing the locker door during
functional testing:
► Adjust the position of the GAT NET.Lock Bolt Set or the door shackle according to the measurements in chapter
"3 INSTALLATION" (depending on the locker material used). If the door shackle is loose and does not remain in
the adjusted position or cannot be adjusted sufficiently, the GAT NET.Lock Bolt Set must be replaced.
► Adjust the position of the locker door according to the measurements in chapter "3 INSTALLATION". If the door
cannot be adjusted sufficiently, install it in a different position. If the door is damaged, replace the door with a
new door.
6.5 Disposal
- Do not dispose of the GAT NET.Lock 7020 or any of the associated components with the normal
household waste, but rather at your local electronic waste recycling facility in accordance with
European Directive 2002/96/EC.
- Recycle defective or used batteries according to European Directive 2006/66/EC.
- Observe local regulations for the separate disposal of batteries.
- Recycle packaging in an environmentally friendly manner.