User Manual

System Setting
42
|
System Setting

Monitor
If you change from monitoring mode to sequence, you will have to set the interval of the sequence.
1.
From <SYSTEM SETUP> - <DISPLAY>, select
<MONITOR>.
2.
Use the [
▲▼
◀▶
/ENTER] button of the remote control
or mouse to set the dwell for Sequence mode and
SPOT Out dwell.

SEQUENCE DWELL : Sets the time interval to
the next screen mode for Live monitoring, which
defines individual screen mode
’
s dwell time in the
Sequence.

SPOT DWELL : Sets the time interval to the next
view type, which defines individual view type
’
s
dwell time for SPOT OUT.
3.
To apply the change, click <APPLY> in the bottom of the screen.
4.
When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen.
The confirmation message appears and you will return to the previous menu.

DUAL MONITOR
When using the Dual Monitor during surveillance, you can also set the screen mode, type, resolution, and other settings.
1.
From <SYSTEM SETUP> - <DISPLAY>, select
<DUAL MONITOR>.
2.
Use the [
▲▼
◀▶
/ENTER] buttons on the remote
controller or the mouse to set each item of the Dual
Monitor.

DISPLAY MODE : When connecting two monitors,
you can set the monitor management type.
-
DUPLICATE THESE DISPLAYS : The same
screen will be displayed on each monitor at the
same time.
-
MAIN MONITOR+SPOT : You can use one
monitor as the main monitor while using the
other as a SPOT output monitor.