Ganz 16Ch Full HD NVR with External PoE Hub, 6TB : User Manual : Page 41

４１

System Setting

3. To apply the change, click <APPLY> in the bottom of the screen.

4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the low

er screen. The confirmation message appears and you will return to the previous menu.

 The above options such as <SENSITIVITY> and <MINIMUM BLOCKS> and how to

set the motion area may be restricted depending on the specification of the connected c

amera.

Motion Area Setup

From the motion setup window, click <AREA SETUP> in the right corner to display the are

a setup screen. Setting the motion area may differ depending on the camera model. Below is

a typical setting of the motion area.

1. Click <AREA SETUP> to move to the motion

area setup screen.

2. If using the remote control, press the [ENTER]

button to mark the current position.

3. Use the arrow buttons to move to a desired

block and press [ENTER]. The area setup will

begin.

Then, use the arrow buttons to specify the area.

Alternatively, you can use the drag-and-drop

method to specify or release the area as using mouse.

4. If you select the specified area again, it will be released.

5. Press the [EXIT] button on the remote control or right-click any area to display the

popup window as in the right picture.

6. From the popup window, move to and specify

the <SENSITIVITY> and

<MINIMUM BLOCKS> for the current channel.

> CHANNEL : select a channel that you specify

the sensitivity and minimum blocks for.

>SENSITIVITY : 1(Low) ~ 10(High) - The higher

the number is, the more higher the sensitivity

level becomes.

>MINIMUM BLOCKS : 1(High) ~ 10(Low) - The

lower the number is, the higher the sensitivity level becomes.

> DAYTIME SET : specify the time period that will be considered as daytime.

> DAYTIME : specify the <SENSITIVITY> and <MINIMUM BLOCKS> for the daytime.

> NIGHTTIME : specify the <SENSITIVITY> and <MINIMUM BLOCKS> for the nighttime.

Images recorded in a low contrast scene such as at night cause severe noise, triggering the

motion event too often.

If this is the case, reduce the nighttime sensitivity to a degree.