Manualshelf

User Manual

ManualsBrandsGanz ManualsComputers & Accessories16Ch Full HD NVR with External PoE Hub, 6TB
41424344454647484950
４２
System Setting
PTZ SETUP
You can set the camera ID, protocol, baud rate and data transmission speed for each
channel.
1. From <SYSTEM SETUP> - <CAMERA>,
select <PTZ SETUP>.
2. Use [ / ENTER] buttons of the
remote control or mouse to set the address
(ID), protocol and data transmission speed
for each channel.
3. To apply the change, click <APPLY> in the
bottom of the screen. Once clicked <APPLY> button after changing settings,
a restarting message pops up. Click <Yes> to restart the system automatically.
4. Once the setup is complete, press the [EXIT] button of the remote control or click
<CLOSE> button on the bottom to display a confirmation dialog.
Click <CANCEL> to return to the previous menu.
Display Setting
You can configure the display settings regarding the OSD menus, monitor and sequence.
OSD
Configure the settings for the time, title, boundary, icon and language that will be displayed
on the screen.
1. From <SYSTEM SETUP> - <DISPLAY>,
select <OSD>.
2. Use the [▲▼◀▶/ENTER] buttons on the
remote control or use the mouse to set each
option of the OSD item.
> CAMERA TITLE : specify the display of the
camera title on the screen.
> RECORDING MODE ICON : specify the
display of the record mode icon on the screen.
> AUDIO ICON : specify the display of the audio icon on the screen.
> STATUS BAR ON FULL SCREEN MODE : select to show or hide the status bar in
full screen mode.
- AUTO HIDE: place the cursor in the lower area of the screen to display the status bar.
If moving the cursor up, the status bar will disappear.
- ALWAYS ON: The status bar will be displayed at all times.
- 5 SEC ~1 MIN: If no mouse movement is detected for from 5 seconds to 1 minute,
the status bar will disappear.
> TIMELINE ON FULL SCREEN MODE: select to show/hide the timeline in full screen mode.
AUTO HIDE : place the cursor in the right corner to display the timeline. If moving the
cursor to the left, the timeline will disappear.
- ALWAYS ON : The timeline will be displayed at all times.
- ALWAYS OFF : The timeline will not be displayed.