User Manual

５１
System Setting
Detail Status
You can check the details of the cameras that are
connected to each channel.
Click < > in the right area of the list to show the
details. Click <RESET> in the “IP CAMERA
CONFIGURATION” window to reset the IP camera.
When the IP camera settings are complete,
click <OK>.
Security
For security purpose, you can set whether to use encryption and its method, and configure
IP filtering.
1. From <SYSTEM SETUP> - <NETWORK>, select <SECURITY>
2. Use the [▲▼◀▶/ENTER] buttons on the remote control or use mouse to select on
between <ENCRYPTION> and <IP FILTER>.
3. When done, press the [EXIT] button on the remote control or click <CLOSE> in the
lower screen to return to the previous menu.
ENCRYPTION
>RTSP ENCRYPTION ENABLE: Set whether
to apply RTPS encryption or not.
>RTSP ENCRYPTION METHOD: Select the
encryption method.
>HTTPS ENABLE: Set whether to use HTTPS
encryption or not.
>HTTP AUTHENTICATION METHOD: Select the
authentication method for encrypted
communication.
IP FILTER
>IP FILTER ENABLE : Set whether to apply
IP filetr or not.
>IP FILTER RULE: You can select to allow
or deny IP addresses listed in the IP filter.
>ADD:Click the button to add an IP address
to be filtered, if IP filtering is enabled.