Manualshelf

User Manual

ManualsBrandsGanz ManualsComputers & Accessories16Ch Full HD NVR with External PoE Hub, 6TB
61626364656667686970
６４
System Setting
System
>BOOTING EVENT: This event occurs when the
NVR is booting.
>LOGIN FAIL EVENT: This event occurs when the
NVR fails to log in.
You can specify the times of clicking < > to
trigger the event.
>FAN ERROR EVENT : This event occurs if the CPU
cooling fan or unit's cooling fan does not work at all.
If the fan fails, no recording will proceed by the NVR.
If you encounter a fan failure, contact the retailer or
the service enter for technical assistance.
>TEMPERATURE FAIL EVENT : This event occurs if the internal temperature of the NVR exceeds
the effective range. Then, the NVR will not operate normally. If this is the case, check the
followings and take a necessary measure.
- Check if the ventilation of the NVR is clogged with foreign substances. If so, remove them.
- Keep the NVR away from a heat source such as heater. Install it in a flat, lower area with good
ventilation.
- If the problem persists, contact the retailer or service center.
>POE FAIL EVENT : This event occurs if power consumption reaches specified level of power
supply capacity of NVR and external PoE Hub.(NR16H)
To monitor the normal operation of the NVR, it is recommended not to change the buzzer output
settings of the fan failure event and the temperature fail event.
Network
>TROUBLE IN INTERNET CONNECTION : Occurs
if the Internet connection to the NVR fails.
If you do not want to connect the NVR to the
network, leave the <Action> item blank.
>FAIL IN REMOTE LOGIN : This event occurs if a
remote client fails to log in due to an invalid ID or
password.
You can specify the times of clicking < > to
trigger the event.
>FAIL IN DDNS UPDATE : This event occurs if the
NVR tried to update the DDNS address but failed.
If the DDNS address fails to be updated,the NVR may not connect to a remote client.
If this is the case, enter the IP address from the client side to allow access from the NVR.
This is just a temporary measure.
For the IP address, move to and check <EXTERNAL IP ADDRESS> from the
<NETWORK> window. Note that the <EXTERNAL IP ADDRESS > is subject to change if
the NVR does not use the static IP.
Note that the <EXTERNAL IP ADDRESS> can change at any time in a dynamic IP
environment.