Instruction Manual

᧭᧲

INSTALLATION

Network Connection

PC connection in the local network

You can connect NVR to a PC in the same network and control or manipulate it on the PC monitor.

1. Connect the [WAN(UPLINK)] port in the rear panel to the router or hub.

2. Connect the local PC to the router or hub.

3. Enter the address in the address bar (web browser) of the local PC or of the dedicated

software program in the format of ಯhttp://IP address:web service port ರ.(Ex : http://192.168.

1.23:8080) The web service port is set to 8080 by default. From the Network Setup screen,

you can change the port number.

4. Provide the ID and password before logging in. Then, you can view the monitoring screen.

5. Access ID (factory default) : ADMIN, P/W : 1234.

9 For the security purpose, change the password right after you purchased the product.

Camera1

Camera2

Camera3

Camera4

Camera5

Camera6

Camera7

Camera8

Local PC

Broadband Router

Hub

Broadband Router or Hub

Local PC